Swapping 144 out to dragon 155 ?s

[mountaintop]

Wanting to swap 144 track out on 03 edge and have a 155 out of an 09 dragon, what drivers etc needed to complete the swap?

 

[E-Zmoke 4:20]

Is the new track a 2.86" pitch? Your stock drivers that are in your sled should work. Problem you may encounter is you will be pretty close to your front cooler and bad snow evacuation out the front of the tunnel. Perhaps look into a front cooler remove, drop n roll, or extended chaincase. Also are you using the suspension from the dragon as well? or doing rail ext?

 

[Hardass]

I think the 03 was a 2.52 pitch?

 

[2XM3]

yup 2.52 pitch so driver change is needed, also track will hit without drop and roll. Not much room in a stock edge Just crawl under there and figure the paddles will be 2.4 inches.

 

[DBLE_O]

One of my friends did this same thing this season. We had to trim 1/4" off every lug, way too tall. He went to 2.86 Anti-Ratchets also. Along with 151" rails and 8" bigwheels, ran the track way loose. There really isnt a point, and a waste of money, unless you have a drop and roll.