I used the solid mount from a 440 Sno Pro on my extra mount bracket, bottom of motor mag side clamping to the aluminum tube running through the bulkhead, same as WYOBOY1000 did I also used grade 8 bolts on the clamp. Looking for opinions if this will be OK Thanks?
Solid Mount on Extra Motor M1000?
- Thread starter RMKing
- Start date
D
doudea
Well-known member
Im looking to do the same thing, was the torque arm an AC part number? If so do you know the part number?
I put a solid 50 durometer in my mag side motor mount, the front of the pto side plate, and a 40 duro in the rear upper of the pto side plate, then built a custom bracket and used a stock motormount under the oil tank. One ride and the mag side mount was broken off the bulkhead.
Yes, the thing shakes. BAD.
Yes, the thing shakes. BAD.
Last edited:
Been there and done that to on the upper mag side/putting in the solid mount and it did the same thing broke that tab off so I had it welded up and used the soft web'd mount from my new lower bracket up top and subbed the solid mount into my new mount bracket mag side running horizontally to that bulk head tube in the chassis, my mount point on the motor was off the two 12MM holes on the bottom of the engine with a piece of quarter/two inch aluminum angle that I built a bracket out of. Yes it shakes alot more at idle but smooths out on the gas and the motor seems way more solid now when watching it run.
Similar threads
