SLP Air Horn Issue

[markowinnipeg]

this past summer I changed the fuel filter installed slp intake filters and put on slp air horn. After about 30 miles riding when I stop sled would not drop down from 3000. Then when it did I got a check eng code of 4pm flashes.
Then when riding it developed a low and mid throttle bog like it was loading up and even had a miss but when pinned ran good.
it would come and go.
what is wierd is when stopped at high idle if I open hood idle goes to normal close hood and idle jumps up.
any idea's what is going on I am thinking slp air horn not sealing good and letting under engine air in?

 

[Kraven]

CHECK YOUR THROTTLE BODY BOOTS

this past summer I changed the fuel filter installed slp intake filters and put on slp air horn. After about 30 miles riding when I stop sled would not drop down from 3000. Then when it did I got a check eng code of 4pm flashes.
Then when riding it developed a low and mid throttle bog like it was loading up and even had a miss but when pinned ran good.
it would come and go.
what is wierd is when stopped at high idle if I open hood idle goes to normal close hood and idle jumps up.
any idea's what is going on I am thinking slp air horn not sealing good and letting under engine air in?

Remove your air box.

CLOSELY inspect the rubber throttle body boots as I suspect they're ripped/torn

 

[markowinnipeg]

the code was for barometric metric pressure sensor looks like I may have pinched air line when I put clutch cover back on. Rerouted the line will see tomorrow.
I will also take a look at intake boots as I noticed with the new foam on slp air horn it moves the air box down which could be opening a crack.
How the heck do you get these air boxes off and back on looks fun?

 

[Kraven]

the code was for barometric metric pressure sensor looks like I may have pinched air line when I put clutch cover back on. Rerouted the line will see tomorrow.
I will also take a look at intake boots as I noticed with the new foam on slp air horn it moves the air box down which could be opening a crack.
How the heck do you get these air boxes off and back on looks fun?

NOT E.Z on the airbox re-install

Just loosen the clamps all the way , the rest requires lotsa patience

A real P.I.T.A.

 

[markowinnipeg]

Took sled out riding today and runs great so turned out to be a pinched sensor line hard to believe that could cause a sled to run so bad.
Thanks for your help Kraven