Im already messing with my yamadoo to get my header setup the way i want it as i dont like version 1... so im thinking instead of dumping exhast out the roll for the chaincase in the belly pan, dumping it out the side panel... i will link a picture to give an idea of where im thinkin about going with it. I know it will be a LOT louder, i was just worried about carving and bogging issues... check back with info, i know some 2 strokes have issues, just curious about the 4 bangers.
heres a side shot, i was thinkin right at the front of the orange rectangle on the side, its not super high, but its also recessed, so might help.. i would just open up the notch for that has mesh on the front. where the ornage gets smaller, that is mesh where going up in front of it, you cant really see it, but its there.
heres a side shot, i was thinkin right at the front of the orange rectangle on the side, its not super high, but its also recessed, so might help.. i would just open up the notch for that has mesh on the front. where the ornage gets smaller, that is mesh where going up in front of it, you cant really see it, but its there.
