setting around

[beamslayer]

Since my sled is going to be setting around for awhile I thought I would start working on my seat.
1-? what is the best seat material as far as covering goes. I not looking to buy a cover just the material .

2-? I have seen where a couple of guys have cut down the padding and wonder what there thoughts where after it was done.

3-? I am going to shorten the seat also and was thinking about adding a little storage compartment. Big enough to carry tools,folding saw and a flask just in case I run into a sno snake.

4-? How do I get rid of that snowest add on the right hand side of the page.

Thanks BS

 

[Old Scud-doo]

Since my sled is going to be setting around for awhile I thought I would start working on my seat.
1-? what is the best seat material as far as covering goes. I not looking to buy a cover just the material .

2-? I have seen where a couple of guys have cut down the padding and wonder what there thoughts where after it was done.

3-? I am going to shorten the seat also and was thinking about adding a little storage compartment. Big enough to carry tools,folding saw and a flask just in case I run into a sno snake.

4-? How do I get rid of that snowest add on the right hand side of the page.

Thanks BS

1. Not sure
2. Haven't actually seen one yet. Other than Boss seats. They tend to be larger though than the 2013.
3. I haven't seen this done either but would be a cool feature.
4. Take the flask out from the seat. Drink it completely and look to your left. That one was easy.

 

[beamslayer]

That was alot of help. I tried the flask trick now it is on both sides.