Anybody know what this means? Also idles high. Runs good though.
service engine comes on at startup?
- Thread starter Way2Fast
- Start date
That is a service interval reminder, it will flash a few times every start-up and then go away. You can disable it or reset it to a higher interval if you wish, the instructions are in the owners manual.
How high is your idle at start-up and does it slow down after a minute or 2 as the sled warms up?
Mine will commonly idle around 1800 for the first few minutes while it is cold then settle down to around 1450 once warmed up, pretty common really.
How high is your idle at start-up and does it slow down after a minute or 2 as the sled warms up?
Mine will commonly idle around 1800 for the first few minutes while it is cold then settle down to around 1450 once warmed up, pretty common really.
D
Danbot
Well-known member
I copied this from my owners manual:
MFD Digital Display Programs
History Program
Service Interval Reminder
The gauge logs the number of engine
hours between service reminders.
When the logged hours reaches the
designated service interval (set by the
user), the gauge provides a reminder
that service is due. “SErVCE” will
flash in the odometer area and “ENG”
will flash in the icon area for five
seconds each time the vehicle is
started until the service reminder is reset.
To reset the reminder at the existing interval:
1. Enter the service interval screen.
2. Press and hold the SET button for ten seconds, continuing to hold
even after the display begins to flash.
3. When the display stops flashing,release the button. The service
interval has been reset.
To reset the reminder at a new interval:
1. Enter the service interval screen.
2. Press and hold the SET button for five seconds, until the hours
begin to flash.
3. Immediately release the button.
4. Press the button again up to five times to advance the reminder in
50-hour increments.
NOTE: The maximum interval is 250 hours.
To disable the service interval reminder, press the SET button once
after reaching 250hours on the display. The gauge will display
“OFF”
MFD Digital Display Programs
History Program
Service Interval Reminder
The gauge logs the number of engine
hours between service reminders.
When the logged hours reaches the
designated service interval (set by the
user), the gauge provides a reminder
that service is due. “SErVCE” will
flash in the odometer area and “ENG”
will flash in the icon area for five
seconds each time the vehicle is
started until the service reminder is reset.
To reset the reminder at the existing interval:
1. Enter the service interval screen.
2. Press and hold the SET button for ten seconds, continuing to hold
even after the display begins to flash.
3. When the display stops flashing,release the button. The service
interval has been reset.
To reset the reminder at a new interval:
1. Enter the service interval screen.
2. Press and hold the SET button for five seconds, until the hours
begin to flash.
3. Immediately release the button.
4. Press the button again up to five times to advance the reminder in
50-hour increments.
NOTE: The maximum interval is 250 hours.
To disable the service interval reminder, press the SET button once
after reaching 250hours on the display. The gauge will display
“OFF”
Thanks for the help I will reset it.
