Secondary Alignment...need help

[800xtreme]

I have a quick question for the clutching expertst (I would have just called SLP but it's Sunday)

I have a 2011 Pro Assault with the TSS 04 secondary. I am trying to adjust my alignment and float use the SLP alignment tool (part # 20-191).

I have also installed the SLP torque arm. The instructions that come with the tool (attached) state there should be a gap between the tool and the front sheave of the secondary of .100. Is that gap measured when the clutch is pushed in, or pulled out against the secondary bolt?

The instuctions do not state either way...

 

[Kraven]

I have a quick question for the clutching expertst (I would have just called SLP but it's Sunday)

I have a 2011 Pro Assault with the TSS 04 secondary. I am trying to adjust my alignment and float use the SLP alignment tool (part # 20-191).

I have also installed the SLP torque arm. The instructions that come with the tool (attached) state there should be a gap between the tool and the front sheave of the secondary of .100. Is that gap measured when the clutch is pushed in, or pulled out against the secondary bolt?

The instuctions do not state either way...

Sent you a P.M.

 

[sled_guy]

Pushed in

sled_guy

 

[800xtreme]

One vote for pushed in, one vote for in the middle (neither pushed in nor pulled out)...I need another vote for a tie breaker

 

[Reg2view]

It's pushed in tight against the shims. Get the C first, then check D. Then set the float. I have the same bar as you, and two different P85's, but no stop.

 

[800xtreme]

Great, thank you!