Remove a Track

[JIMO]

Hi guys,
I have to change my track in the next days .. In the same time I'll change 4 drive bearing. And install Chain Drive ...
Do I absolutely have to open the Frame for to removing the Antiratchet wheels ? ( I hope not )
Thanks

 

[off road rider]

If you have extroverts.. Yes.. its not all that tough and you dont have to totally pull everything apart..On the left hand side of the hawk Run the support, motor plate bolts, etc all the way out, but not removed..might have to take out a few support bolts., drill the rivets on the tunnel, left side only and use a porta power or screw jack to help spread the rails a bit..a little wiggling and maybe a curse word or two should do it...

 

[snowhawkaddict]

I've been around you D.

You know way more than two words!

 

[Hawkdoggen]

It depends on what kind of extraverts and how they are installed , wahls or kinetics for example ( i forget which is which ) any ways one has extroverts on just one side so if they are set to the inside you can usually squeek em out , if their dual sided or mounted facing out .... well a splitn you go ! Hope it helps !

 

[JIMO]

ok thanks guys .