ratching with attack 20

[sickboyz171]

I just installed a attack 20 and wahl bro anti slip drivers and can't get it to stop Ratching any ideas guys thanks kyle

 

[Bauer]

What sled?

I just put an A20 on my Apex and it is loose! Stock drivers, never ratchets.

Dumb question, but are your drivers/track the right pitch?

 

[sickboyz_yamaha]

its a 07 apex mountain. we put the track on, then road about 150 miles and spun the stock drivers. so we upgraded to the wahl bros and cant stop it from ratcheting?

does your track not have the outside drive lug as well? we were think that was the reason..

ran the track so tight that it burnt up slides in no time.. ratchets with no sag in track also.. not right

we need help!!

ordered 3 pitch drivers so they should be the same cuz the track is 3 pitch,, unless they came in the wrong drivers...

this is my buddies sled and its got us all stumped
thanks

 

[sickboyz171]

Ya measured 10 windows and it came out to 30 inchs so it should be a 3 inch pitch, ill try to post a pic later see if are tracks are the same

 

[sickboyz171]

heres a pic

 

[Givemeaboost]

It looks like it wore off the outside lugs.

Ken.....

 

[tard]

It looks like it wore off the outside lugs.

Ken.....

The outside lugs are that way on the atack 20 and the powerclaw. My guess is the track is waay loose, or the drivers are 2.52 pitch. I get no ratcheting on the powerclaw with avid drivers.

 

[sickboyz_yamaha]

Any way we can measure the drivers to make sure they are 3 pitch?..

 

[sickboyz171]

did u get the avids made for the attack 20 and the powderclaw? there still anti slip drivers right its hard to tell by the picture on the website

 

[tard]

I just went with 3.0 pitch avids, switched to a powerclaw to ditch the maverick

 

[twincam88]

my guess is that they are the wrong drives or they are timed wrong i think there is a mark that you have to have pointing the same way on both. might be talking out of my as s though