has anyone install an wideband 02 sensor on their pro rmk? if so where are you getting the power source from? I am getting 858 kit from Rk Tek and gonna hook up the boondocker programmer on it. thought about putting the wideband and keep an eye on the gauge just so i know im not running too lean. so please chime in
Question about wideband 02 sensor
- Thread starter D8rider
- Start date
I used an auxillary power sorce near were the stearing post is supported by the under hood tubing
Two power taps on the pro:
1- DC Power labeled plug-in located in the harness bundle over the clutch cover near where all the grounds connect to the chassis.
2-There is also DC plug-in in the hood harness behind the headlight. It is not labeled but is just kinda hanging out. It is the 2 pin rubber style plug-in. This one is nice if you plan on mounting the afr gauge with your stock mfd on the hood. You then only need to plug/unplug one connector when taking the hood off (from the sensor). I purchased these pigtail harnesses from amazon to wire up my set up. Simply wire the positive/negative to the corresponding wires (red=positive, black=negative). It will then just plug right into the stock aux DC plug in.
http://www.amazon.com/gp/product/B006ZOLDJ2/ref=oh_details_o00_s00_i00
1- DC Power labeled plug-in located in the harness bundle over the clutch cover near where all the grounds connect to the chassis.
2-There is also DC plug-in in the hood harness behind the headlight. It is not labeled but is just kinda hanging out. It is the 2 pin rubber style plug-in. This one is nice if you plan on mounting the afr gauge with your stock mfd on the hood. You then only need to plug/unplug one connector when taking the hood off (from the sensor). I purchased these pigtail harnesses from amazon to wire up my set up. Simply wire the positive/negative to the corresponding wires (red=positive, black=negative). It will then just plug right into the stock aux DC plug in.
http://www.amazon.com/gp/product/B006ZOLDJ2/ref=oh_details_o00_s00_i00
Check out wildchild's gauge relocator and boost/afr gauge holder. I really like having all my vital information in one location. Plus he builds a very nice product!
candasledparts.com
candasledparts.com
H
Hairy Mark
Well-known member
another thing that you should do is call boondockers. they sell a neat little plug that plugs directly into the dc power source at your handle bars the other end of the plug is the two pin pigtail that will connect on the link above. cost me $12 delievered to my door. you can also get the amazon pigtail at your local napa store. probably the nicest O2 sensor i have found is the innovate mtx-l. you can get them on line for about $160. water resistent and very tough.
