Just trying to wire in the new prologger and the wiring diagram shows opposite of what actual wiring diagram is. ie # 5 is where #10 is and #4 and #9 are reversed, etc. is this how everybody is running or????any help would be apreciated....
Prologger wiring diagram
- Thread starter jrey
- Start date
What wires did u guys not use, i am not running nos or meth injection just the turbo.
Green/Blue/tan are not used
Purple connects into the green/black on the stock harness( I go in right beside the connector for the purelogic)
Yellow Pink and Brown make up your male 3 prong connector to plug into the Map Sensor.
Grey goes to one spot on the 2 prong connector (connects to the boost control valve female end) then for the other spot on the 2 prong connector connect a wire into the blue/white wire on the loose connector above the battery and up to the left. (it comes off the main harness close to where you plug in the rear fuel power source, it does not plug into anything but has a plastic connector on it)
Red goes has a fuse in line and runs into the Prologegr relay you build.
Black is ground.
I have the wiring for the relays as well if you need help there.
Motleyone
Purple connects into the green/black on the stock harness( I go in right beside the connector for the purelogic)
Yellow Pink and Brown make up your male 3 prong connector to plug into the Map Sensor.
Grey goes to one spot on the 2 prong connector (connects to the boost control valve female end) then for the other spot on the 2 prong connector connect a wire into the blue/white wire on the loose connector above the battery and up to the left. (it comes off the main harness close to where you plug in the rear fuel power source, it does not plug into anything but has a plastic connector on it)
Red goes has a fuse in line and runs into the Prologegr relay you build.
Black is ground.
I have the wiring for the relays as well if you need help there.
Motleyone
Last edited:
