I recently cleaned out my VES valves, one of which was rough. My main concern is I cant find upgrades for the guillotines and theres no vacuums lines or hookups o. The housings. 2003 just engine vacuums operated???
Polaris VES help.
- Thread starter slighwilly49740
- Start date
Someone at some time made stainless steel guillotines for that sled. I remember reading about it here. I run the same thing. I replace my bellows every two years or so and always keep a spare one on hand. A little emery cloth to take the crap off and I run fine.
So no vacume lines? Mine have holes in tip the plastic housing but no threads and areas for attachments.
So just engine pressure ran?
So just engine pressure ran?
Anyone have a link for replacement guillotines? Everything I find is for Polaris 600 not 800.
The VES valves are operated by pressure from the engine thru a small hole in the cylinder jug. The nipples on the valves ( vent nipples) with vacuum hoses went to a switch that was electronically controlled by engine rpm. Putting caps on the nipples will just allow the VES valves to be controled by engine pressure and not the electronics---- they usually run better that way (nipples capped off) simple vacuum cap and small tie wrap) . Diffrent color springs are avaliable to control opening.
