Polaris axys-R 600 race 2021

[LOLO21]

I have 2 questions, is it normal that when I crash my ass the suspension goes up but a few centimeters remain crushed, perhaps so as not to reach the end of the suspension's travel?
and for the intake side on the exploded view there are 3 foams, but on mine, I don't have any I have a frogzskin kit (wind kit), should I put the extra foams or not necessary?
Thanks in advance

 

[volcano buster]

Used sled?

 

[LOLO21]

Used sled?

yes it but it is almost new, it is 8 hours old

 

[volcano buster]

Your description of the motion of the rear suspension is a bit unclear.
The intake foam/frog skin may have been an "upgrade" by the previous owner. Better? Who knows.

 

[LOLO21]

Your description of the motion of the rear suspension is a bit unclear.
The intake foam/frog skin may have been an "upgrade" by the previous owner. Better? Who knows.

ok, for the suspension, when I crush the ass, it goes up well but there is still 2 or 3 cm which remains depressed, if I raise the cuĺ, the 2 centimeters go up to the maximum stop of the cylinder, should the rear suspension go up in the cylinder stop or there can be 2 centimeters so as not to reach the end of the stroke?
for the event kit I just wanted to know if I need to put the original foams in addition to the frogzskin kit, is it a prefilter or if it does both, prefilters and filter
thank you very much

 

[PSI 800]

a little suspension sag is normal. I dont think i would worry about the intake foam

 

[LOLO21]

for the suspension I was wondering if it was normal that the cylinder did not return to the end of its stroke so as not to reach the cylinder stop by 2 centimeters.
for the frogsking kit, is it a pre-filter? Should I add the original filter foams?
THANK YOU

Your description of the motion of the rear suspension is a bit unclear.
The intake foam/frog skin may have been an "upgrade" by the previous owner. Better? Who knows.

for the suspension I was wondering if it was normal that the cylinder did not return to the end of its stroke so as not to reach the cylinder stop by 2 centimeters.
for the frogsking kit, is it a pre-filter? Should I add the original filter foams?
THANK YOU

 

[LOLO21]

a little suspension sag is normal. I dont think i would worry about the intake foam

thank you