I was wondering if someone could help me out please, i have a 2010 crossfire 800 ho sno pro and it has a intermitten hesitation in the motor. heres what iv done so far, checked the servo motor for power valves=good, pulled and cleaned power valves=done, reset power valves=done,checked tps=good,had to replace reed valves=done, had ecu box hooked up to computer several times=no codes. oemed out all wires comming from servo motor and tps=good. im at a loss. if you leave it idle it runs fine, when your getting on it its missing and eventullay will go to one cylinder, then idleing down it goes back to both. this is a new one on me and iv been working on sleds for years, anybody out there have any ideas for me as i dont really know where to look next.
thanks much for your help
thanks much for your help
