Pipe repair in Denver metro?

[BackCountryBob]

Have 1" round dent in my 04 REV pipe. Anyone know where I can get it repaired? Thanks.

BCB

 

[rxlrider]

Unless you have seen a decline in performance, a 1" dent should not do anything to effect your pipes scavenging abilities. If it were me, I would get a dent puller from an automotive supply store, screw it in to the center of the dent and pop it out. You could fill the small hole with a little weld.

Brad

 

[Moqui]

Vickery Motorsports can fix it. 303-755-4387

 

[Ex-Member]

i wouldn't trust vickery with my sled, personally. They didn't do a very good job when I took it there.

I'd go with the dent puller idea, If you need a welder, I know a guy in lakewood that does a great job.

 

[Mrs Snowrider]

Did you go to RE Saturday? We waited for you. . .

 

[Snoman69]

Plug one end, plug the other with the ability to blow air in, heat up around the dent and use air compressor to blow in... Make sure that the plugged end is not facing anything, as it can pop and will cause damage if it does.

 

[Rprecision]

alother option along the lines above.......

Go to a pluming supply store and get a test block off, they look like a round intertube with a tire valve on them...

Inflate it inside that portion of your pipe

 

[BackCountryBob]

Thanks for all the replies--I think I'll ride it as is and see how it goes. BTW, the tree hugger standing infront of the tree moved out of the way just as I was about to hit him/her/it

BCB