Picked up my 2015 and added a few things

[toofpaste]

Got her home and did my usual first small mods. I always install an RSI throttle block since I have broken three stock plastic blocks. Got a quick drive skid plate from Tedd, and added the tether. I was going to add my mountain addiction tracks, bag, and cans.....but I'm leaving them on 2014 for now.

 

[toofpaste]

 

[toofpaste]

I still need to pull the reflectors and stickers.

 

[mountainhorse]

Looks Good!!

Thank you for taking the time to put up photos for us to ogle.

I like the reflectors pieces.... they are makes you much safer at night.

 

[fastrack0]

Very nice

 

[caboussleman]

Where did you get the tether at ?

 

[toofpaste]

Where did you get the tether at ?

I always just buy the polaris tether at the dealership. It's plug and play. Never had one go bad yet.

 

[Sage Crusher]

How about the Teds QD skid Plate? Like to know where to get one-
Also do you run a skid plate for the bulkhead? Didnt see one.

Sweet looking sled- love the front bumper on it.

S/C

 

[simnil]

Is it possible to remove the stock throttle block without removing the handle bar grip and heating element?

 

[jonasumb]

Congratulations on your new ride, she is sweet

 

[toofpaste]

How about the Teds QD skid Plate? Like to know where to get one-
Also do you run a skid plate for the bulkhead? Didnt see one.

Sweet looking sled- love the front bumper on it.

S/C

Link to the VA skid plate at Tedds
http://www.teddunlimited.com/Pro-RMK-Belt-Drive-Skid-Plate-VEI-004-PG-D.htm

I have always run a skid plate, but actually forgot to get one while at the dealer.

 

[toofpaste]

Is it possible to remove the stock throttle block without removing the handle bar grip and heating element?

Yes, the stock throttle block separates. It does not slide on/off the bars. Take the large alen set screw out of the bottom, four screws on the end, remove the flipper pin, pull throttle cable out of the holder and leave the flipper attached to the cable. The bottom piece of the stock throttle slides out of the upper portion.

 

[simnil]

Yes, the stock throttle block separates. It does not slide on/off the bars. Take the large alen set screw out of the bottom, four screws on the end, remove the flipper pin, pull throttle cable out of the holder and leave the flipper attached to the cable. The bottom piece of the stock throttle slides out of the upper portion.

Ok thanks. Have been away from Polaris for four years, (last one was a -09 Assault), but have a -15 RMK 800 on the way. One thing I remember not liking was the sloppy feel of the throttle flipper when the pin moves between the emergency breakers.
I will be doing something about that.
Does the ECU become "irritated" if I remove these emergency breakers? Think I saw something written about that somewhere.