Parting out the "problem child" 04 rev X

[Van Epps]

GONE!

Thanks for looking!

 

[Van Epps]

ttt

 

[TylerG18]

how much for the seat and two wheel kit and possible our skis let me know thanks

 

[i'llDooit]

i'd be interested in the gas can. possably more. pm me with a price

 

[X2Freeride]

How much for it as a roller. The bulkhead isnt that hard to replace.

 

[bikerjustin]

What is your opinion of the 44/40 helix? What secondary do you have and what is your setup in the primary? I have been considering that helix but a few people keep advising I keep the straight 44 and if I need more clamping just run a straight 40. As a rider, not someone selling a part, what did you think of it? I know you chased demons for a season, were you able to even get a feel for it?

 

[Van Epps]

I really liked the 44/40 from what I could tell. Unfortunately I didn't get a real good feel due to run ability problems I was chasing. From what I COULD tell it worked really well, I was excited to run this set up with good running motor but no luck!

Im selling her as a roller at this point, asking $1700.

 

[jacmmaxwell]

Did you sell the seat? intrested.

 

[Van Epps]

Going to sell as complete roller, sorry.

 

[kelwar]

when you say roller are you talking about a rolling chassis with out an engine?
thanks

 

[Van Epps]

Yes, no motor or motor plate, clutches or mpem.

 

[kraut]

?

Do you think an RX-1 motor would fit in that thing? Or would it need to be a RT chassis? nice sled

 

[Van Epps]

I don't think so. You can put a cat 900 in it. I had a guy planning to do this but finances bit him in a hard way recently so...........

IMO a built Cat 900 or 999 would be very cool in this chassis. I may do it myself if nobody steps up!

 

[kelwar]

interested in your sled but im up north in dawson creek for the next bit for school