2012 rmk 800, blew top end at 3200 mi.
Cases, have a few dings on mag side. Chip out of edge of reed area by crank. All bearing surfaces and mating surfaces are good. $375
Crank, all bearings and rod bearings are good and rotate tight with no noise or binding. The large pto bearing does have about 1mm play. I would replace it.
$250.
Magneto $50
Stator $90 (I will check resistances before I send it out)
ECM, $125. I will install this and run it in my pro before sending it out.
Wiring harness $40
Voltage regulator and capacitor. $75,
Oil tank and mounting bracket$30
Exhaust pipe $75
Muffler $40
All these parts are best offer and do not include shipping. Paypal preferred
Call or text as I dont get on the forum that often
206 65o o717
Bill
I can send pics by text.
I'll try to get some in the post.
Cases, have a few dings on mag side. Chip out of edge of reed area by crank. All bearing surfaces and mating surfaces are good. $375
Crank, all bearings and rod bearings are good and rotate tight with no noise or binding. The large pto bearing does have about 1mm play. I would replace it.
$250.
Magneto $50
Stator $90 (I will check resistances before I send it out)
ECM, $125. I will install this and run it in my pro before sending it out.
Wiring harness $40
Voltage regulator and capacitor. $75,
Oil tank and mounting bracket$30
Exhaust pipe $75
Muffler $40
All these parts are best offer and do not include shipping. Paypal preferred
Call or text as I dont get on the forum that often
206 65o o717
Bill
I can send pics by text.
I'll try to get some in the post.
