Dumb question - Pulled my clutch apart last night being the needle bearings that allow the belt to sit stationary at "maximum tightness" were not functioning as they should. I was often getting belt squeal etc.
I was able to clean everything up and regrease the interface. However, when I was thinking about this I realized there really isn't a robust seal and this grease could leak out and get all over the clutch/belt.
Does anyone have a service manual and can tell me what Polaris recommends here?
TIA!
I was able to clean everything up and regrease the interface. However, when I was thinking about this I realized there really isn't a robust seal and this grease could leak out and get all over the clutch/belt.
Does anyone have a service manual and can tell me what Polaris recommends here?
TIA!
