hey.
I am planning on putting exhaust on my 08 nytro and i am just wondering what is the best out there.
I am planning on putting exhaust on my 08 nytro and i am just wondering what is the best out there.
Nytro Exhaust
- Thread starter davidm1000
- Start date
Are you going with just a can or the whole system?
i rigged up a small car exhaust with the silencer so you can leave it in or take it out it was cheap and seems to work the same
ya a car exhaust works well i used a ten inch glass pack only took three hours to install and was able to use all stock panels even the tail cone
8
80 ponies
Member
How does it sound, Im thinking of doing the same. I put one on my 07 phazer and it yas way too loud.
ya its pretty loud in the shop cant wait to get it out in the snow to see how it sounds. It still beats the 250 to 700 dollars they want for the aftermarket exhaust systems and you still get the weight saving i saved 6lbs
I bought a super Q from Hartman for the Phazer it is a bit louder than stock
8 pounds lighter (on my scale)
But way quieter than all the others After market systems, a nice compromise.
Fit was perfect and at $240 a good deal.
I would look at it for the Nytro as well I know they have them.
8 pounds lighter (on my scale)
But way quieter than all the others After market systems, a nice compromise.
Fit was perfect and at $240 a good deal.
I would look at it for the Nytro as well I know they have them.
How was the Phazer install? Did you have to cut the stock exhaust to get it to work? My buddy wants to me to help him install a Super Q on his 07 Mtn Lite.
I just installed a AAEN on my 08 Nytro MTX, 6HP gain, 7lb loss, check the vid:
AEEN Exhaust Install 08 Yamaha Nytro MTX
Easy install , cut exhaust and slip on the Super Q fits stock mounts.
I did drill a hole and put a sheet metal screw in the pipe to hold it in position and then Drilled a wide hose-clamp ( SMALL HOLE ) and shaped it over the head of a screw. Put the clamp over the screw on the slip joint to ensure it all stays in place. This makes a very clean install , better than the big muffler clamp that comes with it . Total time is about 1/2 hour to 45 minutes for the first one -- the next one I would do in less than 20 minutes.
Cheers.....
I did drill a hole and put a sheet metal screw in the pipe to hold it in position and then Drilled a wide hose-clamp ( SMALL HOLE ) and shaped it over the head of a screw. Put the clamp over the screw on the slip joint to ensure it all stays in place. This makes a very clean install , better than the big muffler clamp that comes with it . Total time is about 1/2 hour to 45 minutes for the first one -- the next one I would do in less than 20 minutes.
Cheers.....
I went with the AAEN System. Install looks nice and clean and was pretty easy. Sounds great, especially with quiet core removed. Removing it is supposed to boost the ponies by about 1.5 too. Every little bit helps.
