Nytro Coolant Tips

[WOOD2]

I can not seem to get the coolant to flow. I have a cr tunnel so I took the radiator out and have heat exchangers in its place. This is the hardest machine to get all the air out of!!!!!!! Somebody has found an easier way than I. Enlighten my dumb a** please.

 

[M5-]

You're right its a PITA. Try lifting the front end way up like 4 feet way up and let the air work its way to the top.

M5

 

[snowy1]

Chad I didn,t have any problems with mine as said just lift the front up so that the rear cooler is the lowest point, and I filled the rear cooler first. I unhooked the lines coming off the tunnel on both sides and filled from one side until it ran out the other side. hooked up hoses and filled the motor. let it sit over night with the cap off. that way all the air can work its way out if there is any.

 

[up-high]

snowy1 did it right! My cr tunnel was a pain to bleed compared to the stocker. Raised the front and let it sit for a day and bingo good to go!

 

[WOOD2]

Thanks you! I got it now. I hope I never drain the coolant again!!!!!!!!!!