Has anyone bent a drive shaft on there Nitro! Reason for asking is I have a vibration in the drive train that I'm chasing!
Nitro drive shaft ?
- Thread starter Sleds R Fun
- Start date
Could be the bearings going out if you haven't checked them.
Sent from my C771 using Tapatalk
Sent from my C771 using Tapatalk
New bearings all around, collar locks on drivers, some wear on drivers but not bad, drive comming out again this week will let you know!
vibration
what track are you running and what drivers rear axle/ wheel set up suspension? you would have had to hit somthing good to bend the shaft..
I am sure you checked track alignment, how about driver spaceing, rear axle wheel spacing, boggies for damage, lift the back of the sled and have somone spin the track so you can watch it roll around I have seen tracks that have a wobble in them that gives a vibration. I would also look at the rail caps to check for odd wear or missing track clips. julio
what track are you running and what drivers rear axle/ wheel set up suspension? you would have had to hit somthing good to bend the shaft..
I am sure you checked track alignment, how about driver spaceing, rear axle wheel spacing, boggies for damage, lift the back of the sled and have somone spin the track so you can watch it roll around I have seen tracks that have a wobble in them that gives a vibration. I would also look at the rail caps to check for odd wear or missing track clips. julio
P
paulharris
Well-known member
prob just the track vibrating if its a Challenger Extreme 2.5 or larger! I have a 2.5 CE on mine and the track vibrates like crazy and always has since the day i put it on
Last edited:
B
BigFish BC
Well-known member
make sure your drivers haven't spun & are out of time
Similar threads
