Need the spacing for 2 anti spin drivers instead of the 4 stock on a 04 summit
- Thread starter walker
- Start date
Best bet is to just measure from the stock locations, everyone seems to measure differently.
Need to firgure were the center is then go from there. You might have to put the shaft back in to find or find the center between the two oringals.
I measured with a framing square, held one edge on both drivers, and the other edge on the end of the shaft. If you mark the centerline of the drivers, you can't go wrong.
If you removed the drivers already, I would just reinstall the shaft and find the center, like doomama800 said.
If you removed the drivers already, I would just reinstall the shaft and find the center, like doomama800 said.
