Need skid mounting hole measurements

[Nolimits]

I just purchased a 144 xtralite skid for my 98 700 rmk. I need some measurements as to were the mounting holes should be. Rear edge of driveshaft to front mounting hole, center to center front to rear mounting holes, distance from top of tunnel to each mounting hole. Hope this makes sense. Any other tips on this conversion would be great.

Thanks!

 

[Nolimits]

Was hoping to get this mounted this weekend, could someone do some measuring for me please. Any help is appreciated!

 

[MARV1]

Front mounting hole should be same spot, maybe down one hole just drill out pilot hole in tunnel. Rear mount is 4" on center back from current mounting position.

 

[instigator10]

Need to know distance from top of tunnel to drive axle to set up proper tip location.

 

[Mark's RMK]

Mounting holes

http://jbshocks.com/tech.html

There is a good discussion link on harcoresledder.com, Polaris XC