need help

[falk]

I am running with a d&d, pipe and can with a pure logic controller. Is any one run this set up? If you are what are your settings? What elevation? We ride 3000 to 6000 and my green is set on 3, yellow is set on 3 and my red is set on 4. Now it has a terrible bog in the low and mids but it seems if i can get it cleaned out it rips. The digatron reads 1086 around when im wide open. so what do i do start taking fuel away from the first two????

 

[SLEDIOT]

1st of all what sled R u running? Ive run this setup on both my m7 and m1000 with the pure logic box at these particular altitudes. I could help you if you gave a lil mo info..........

 

[falk]

1st of all what sled R u running? Ive run this setup on both my m7 and m1000 with the pure logic box at these particular altitudes. I could help you if you gave a lil mo info..........

The sled is a 08 M8. I guess this might help. My controler box is set at (Green) on #3 (yellow) #3 (red) is on #5. Have not yet set the full throtle setting yet.

 

[SLEDIOT]

Set yer full throttle at 6 and lean yer green to 1, yellow to 1 and yer red to 3. Watch yer engine temps. If you dont have egts get some especially if yer going to run mods........

 

[Alberta Sledder]

I have a similiar sled 08 m8 with twins and purelogic controller. I agree with the last response (i.e.settings) if fuel pressure is also similiar. Mine was very high stock at 52 psi before fuel regulator set to around 40-42ish. We played with fuel pressure/settings for 3 hours today with good results.

 

[holin 1]

My m1000 is doing the exact same thing and i noticed today that a code is coming up ecu 12 manual says igniton coil. I am also running a pipe and pure logic box