O
overboard
New member
Hi. I have a few clutch(primary) pullers but none seem to fit my new pro (2014). Threads are the same, but I have one from my vert escape that I simply want to cut off.
Can anyone tell me the meaurement from the end of the threads to the end of the shaft ? I'll simply hacksaw it off and be good to go I think. See pic.
I'm bilingual so metirc or imperial # will be ok
.
Thx in advance.
Can anyone tell me the meaurement from the end of the threads to the end of the shaft ? I'll simply hacksaw it off and be good to go I think. See pic.
I'm bilingual so metirc or imperial # will be ok
. Thx in advance.
