NA boondocker controller wiring

[Lorduss]

I have the NA/nitrous boony box that im trying to get plugged in (my application is NA) the instructions to me are not completely clear on how I wire this into my pro rmk for the TPS reading.
I have the pigtale inbetween the injectors, the EFI harness.
then I have a plug with a white and orange wire leading off (just wire, no plug) can anyone give me a breakdown on how these fit into my TPS electrical system ? or If I even need to for that matter

 

[mountainhorse]

Post up a photo of the unit you have.

From the sounds of it you have Part #CBA-P018 because you say you have an orange wire.... If so... the Orange wire is for input from an Air/Fuel ratio (A/F) monitor... you dont need to use that...but I would protect it.

What year is your sled?

Did you buy this Boondocker Box New?

There are 3 different models for the ProRide Rmk's...all have different wiring.
1) 2011/12 (Part #CBA-P010)
2) 2013 (Part #CBA-P016)
3) 2014/15 (Part #CBA-P018)

Do you have the correct unit?

Instructions online here. (scroll down for instructions)
http://www.boondockers.com/index.php/

.

 

[Lorduss]

I do have a 2012 pro and I have the CBA-p010 bought new.
So tuck away the orange wire, splice the white wire into what I assume would be the white wire coming off my tps and consider it done?

 

[mountainhorse]

I don't have the 2012 kit... but the online instructions for the box itself say "Refer to the instructions in the TPS wire kit to install the TPS wire. Plug it into the TPS Adapter or Nitrous Harness"

Did they ship it without a TPS instruction sheet?

.

 

[Lorduss]

I did not get a specific TPS instruction sheet
I was able to google a instruction sheet but it references a older Polaris 900 05-07 (I was not able to find the TPS instruction sheet on the boondocker website)


the instructions reference a pos/neg/ and signal wire coming out of the TPS and to splice the white wire into this signal wire


according to some other searching I have done this should be the aqua colored wire with PRO RMK chasse setups
edit: found the page in the service manual, its the blue wire coming out of the TPS, pretty much know what I need to know now, thanks