Just installed the 5 foot auxiliary cooler from mtntk and very pleased with the fit and finish of the cooler. Easy install. Just need snow to see the new temps.
MTNTK auxiliary cooler
- Thread starter seanrohatyn
- Start date
Not sure why the pics rotated. Lol
This makes me excited to get mine installed. I picked one up at Haydays and just haven't put it in yet.
Any tips or tricks for install that I should know or was pretty much just by their instructions?
Any tips or tricks for install that I should know or was pretty much just by their instructions?
I just followed the instructions minus removing the drivers. It's pretty straightforward.
I've been wondering if the install could be done without removing the track and driveshaft, that answers that question.
Yep. More than enough room with the track and driveshaft still in. It's way easier to hang the rear of the sled from the roof than laying it on the side.
I did Moosesp's extra heat exchanger at a length of 24" and I run about 107 degrees in the powder and about 114 degrees on the trail with factory scratchers.
Finally got out to test it. Air temp was -24*C with hard pack drifts no scratchers down. Some ditch banging and playing in sloughs. Never climbed over 127*F. A great investment on this machine.
coller
well after reading this I ordered one for the wife's sled. hope it helps
well after reading this I ordered one for the wife's sled. hope it helps
The only major drawback I see is that I'm the last to join the group since I have longer warm up time.
