A buddy and i were talking about ways to extend the life of the mounts and were thinking about filling the spaces with a silicone this would also decreases movement or play in the mounts and help with belt life while still soaking up engine vibration. what its your guys take on this? anyone already tried it?
Motor Mount life Extension?
- Thread starter burty
- Start date
S
sledneck_03
Well-known member
Could machine some brass ones. Had solids on our outboard. Shook stuff loose all the time, you would find screws and nuts every once in a while on the floor.
Have you tried torque arms?
Have you tried torque arms?
yes, 2 side mounts ( clutch side) were scrap after 2000km on mine. are torq arm are a good upgrade on engine mounts life?
800 miles i had 2 mounts shot,added slp torque arm fixed the issue belts last longer as well, just need to make a good fan to pull air out and i should be set and maybe fire and ice torque stop as well
S
sledneck_03
Well-known member
the vents in the clutch cover above the secondary are covered by the tool bag. I took my tool bag off and am going to pop rivet it somewhere else. its right where the fan goes on the blow hole. was thinking of getting holz dash vents and putting a fan on the holes in the belt guard.... $70 vents, $50 fan. under half of what the blow hole is.
Similar threads
