Measurements for Extrovert Placement on MM700 Drive Shaft

[Frostbite]

I am trying to determine extactly where to place the extrovert drivers on a MM700 shaft. I went to the Avid site and nothing, I went to Wahl Brother's and there are no longer measurements there either. I tried MPI with no luck.

Does anyone have the measurements handy?

Frosty

PS: I plan to use take off Nytro MTX 7 tooth 3.0" pitch drivers on the MM700 for the 153" maverick. I will be using all four drivers but the placement of the extroverted drivers will help me determine where the involuted drivers should be placed inside of the extroverts.

 

[snowdad4]

measure off the gear side of shaft 11 9/16" to find center. measure your track window center to center, should be 9 1/8". off shaft centerline, 4 9/16" center to center on drivers. if you havent pressed the existing drivers off yet, you can find shaft center by splitting the measure between the two. i use a flat surface and a speed or tri square for accurate measures. then double check with the track windows.

 

[M.M. 700]

http://www.snowest.com/forum/showthread.php?t=114176

 

[Frostbite]

Thanks Guys!

I certainly appreicate your help.

Frosty