D Duzzi Well-known member Lifetime Membership Oct 26, 2014 #1 Anyone have a break down on pulling the Diamond drive apart? I have new bearings and seals I want to install. I have done it on a 06 m7 without reverse. Any tips or links would be appreciated.
Anyone have a break down on pulling the Diamond drive apart? I have new bearings and seals I want to install. I have done it on a 06 m7 without reverse. Any tips or links would be appreciated.
A arctic2009 Well-known member Oct 27, 2014 #2 pull up a parts breakdown from any parts finder websites. country cat has one on their website.
av8er Well-known member Lifetime Membership Oct 27, 2014 #3 x2 pull the rubber stopper out, and take out the 4 torx screws by the toe hold side plate. then remove all DD bolts, bang on it a little from the back side with a rubber hammer.
x2 pull the rubber stopper out, and take out the 4 torx screws by the toe hold side plate. then remove all DD bolts, bang on it a little from the back side with a rubber hammer.
