M1000 SLP Boondocker #'s

[ditch1000]

Whats everyone running for Boondocker numbers on a 08 M1000 (with reflash) with a full SLP pipe setup and BDX Box. So far, I have had to add alot to the 5000, 6250 and 6500 RPM ranges over what SLP has in their instructions. 5000, I'm at 1,2,0; 6250, I'm at 1,2,0 and 6500, I'm at 1,1,0. Are you guys coming up with the same type of numbers??

 

[MR MOOSE]

Part of your problem could be with the fuel pressure regulator, depending on where you have it set could change your numbers quite a bit. I dont run a regulator and know that its a different brand of pipe I'm running but my numbers are way off of yours and I couldnt be happier with how mines running.
Heres my #'s (keep in mind no regulator!)
3000 -3 -3 -4
5000 -4 -7 -7
6200 -9 -10 -11
6500 -4 -5 -11
6850 -6 -6 -10
7250 +4 +6 +8
7850 +10 +15 +23
I'm seeing around 12.3 A/F on a long hard pull, good luck.

 

[ditch1000]

Part of your problem could be with the fuel pressure regulator, depending on where you have it set could change your numbers quite a bit. I dont run a regulator and know that its a different brand of pipe I'm running but my numbers are way off of yours and I couldnt be happier with how mines running.
Heres my #'s (keep in mind no regulator!)
3000 -3 -3 -4
5000 -4 -7 -7
6200 -9 -10 -11
6500 -4 -5 -11
6850 -6 -6 -10
7250 +4 +6 +8
7850 +10 +15 +23
I'm seeing around 12.3 A/F on a long hard pull, good luck.

I have a BMP regulator, mine is set at 43 lbs, I believe. The sled is starting to run the best it has since I put the SLP pipe on it. Mine A/F is about 12.6 to 13.3 in the mid range where it was bogging. The bog it almost completely gone now, so I'm getting close. WOT is at 13.3, that's lean but right now I'm mainly boondocking, so when I get to the mountains again I'll add a couple points to the 7850 high and that'll clean that up.

 

[Rye23]

get the pc V. im sick of pissing around with the bd box. SLP sent me a PC V with map installed for my 08 M1000 with the reflash. A pull the rope and go!