Low Windshield
- Thread starter deschutes
- Start date
T
theshadowrider
Well-known member
They have a few on pure polairs parts. Are you thinking of something like this?
http://www.purepolaris.com/Detail.aspx?ItemID=2875990(PolarisPGACatalog)
http://www.purepolaris.com/Detail.aspx?ItemID=2875990(PolarisPGACatalog)
Don't spend the $80.00 from Polaris. Just cut it down yourself. I marked it out with a Sharpie and then used a box knife to cut it out. Looked much better than the stock windshield IMO.
T
theshadowrider
Well-known member
I think he said he already cut it and doesn't like it cut. I think the cut looks better but at some angles it does look like its missing something. Tons better than having an old mans windshield though.
I just took an old street bike windscreen and used the curve of that to mark my line... just move something like that up and down until you see what you like! After that cut it and use some kind of glue to put the ruber/plastic edge cap back on may have to cut the length of that down a little bit. Hope this helps I came out with the same result as all the pictures you see above.
ditto...just spray paint the inside/underside with flat black spray paint. Screen does nothing but the hood looks funny without it...super low profilers don't break off though so that is nice. Used to go through alot of windscreens in the day.
rob you should have wrote super low profile are hard to break off mine was cut to as low as your and broke mine off now i run without it
you would be amazed at what can break off in an end over end backwards even in deep snow although it was pretty heavy snow
