Listed is a Rotax 780 3 cylinder tripple motor. It was built by one of the industries best engine builders "Paul McCloud". It has trail porting done on the case and cylinders, combined with Crank Shops cylinder spacers, cut head, bored 44mm carbs and carbon fiber reeds. I can no longer locate the dyno sheet that came with it when purchased but it will produce 189 HP and 114ft/lbs torque of 91 octane. This motor is a little powerhouse yet has great longevity and will probably out live any chassis it's ever put in.
I just put a new top end on this motor which has yet to be run and had the cylinder head custom powder coated red. You will need to do a proper break-in on it!!! I noticed light scuffing on the piston face and desided to fix it before any major motor damage occurred. I will send those pistons with and could be used as spares if needed at a later time. The motor also is on the first overbore making it 809cc.
It will come with everything listed below:
Complete 780 motor with electronics
fuel pumps
Mikuni 44mm round slide carbs
Cranks Shop trail pipes with silensors rated for 8800-9000 rpm range
Comet 3 post primary clutch
Asking price is $1300 plus shipping or transport fees. Motor is located in Western Montana and is sold as is with no warranty. I travel for work so please PM me with questions or a contact number as I do not follow the forum like a Facebook post.
![20140613_161017[1].jpg](https://www.snowest.com/forum/data/attachments/190/190532-3edcb5672a828554d2a63d24ba24cbf0.jpg?hash=Pty1ZyqChV "20140613_161017[1].jpg")
![20140613_161110[1].jpg](https://www.snowest.com/forum/data/attachments/190/190540-558824dd772c90fe8df35c4c40eeb67e.jpg?hash=VYgk3XcskP "20140613_161110[1].jpg")
![20140613_161137[1].jpg](https://www.snowest.com/forum/data/attachments/190/190548-4b1c2269d998437b5ef61d0d2a9d0cb8.jpg?hash=SxwiadmYQ3 "20140613_161137[1].jpg")
I just put a new top end on this motor which has yet to be run and had the cylinder head custom powder coated red. You will need to do a proper break-in on it!!! I noticed light scuffing on the piston face and desided to fix it before any major motor damage occurred. I will send those pistons with and could be used as spares if needed at a later time. The motor also is on the first overbore making it 809cc.
It will come with everything listed below:
Complete 780 motor with electronics
fuel pumps
Mikuni 44mm round slide carbs
Cranks Shop trail pipes with silensors rated for 8800-9000 rpm range
Comet 3 post primary clutch
Asking price is $1300 plus shipping or transport fees. Motor is located in Western Montana and is sold as is with no warranty. I travel for work so please PM me with questions or a contact number as I do not follow the forum like a Facebook post.
Last edited:
