I broke my kill switch and could use some help replacing it. Can anyone give me some advice on how to remove the pin connectors out of the plastic electrical housing? I think the pin connector is held in by a couple little tabs and there must be a trick to getting them out without breaking it.
Kill switch replacement on XP
- Thread starter moderatebill
- Start date
Hey,
I've done a bunch if kill switches and hand warmers. I cut the wire close to the pins and get a punch and push them out forwards.
I've done a bunch if kill switches and hand warmers. I cut the wire close to the pins and get a punch and push them out forwards.
use a dental pick, on the bottom of the pin (the side that the small clamps are bent around the wire) push in and down while gently pulling on the wire. there are 2 metal tabs on the pin that click past a plastic tab inside the connector housing.
Forget the ski-doo kill switch and buy a Suzuki RM kill switch and wire it in. It is very easy to do and you will not break it as it is small, and durable, where the doo switch is not either, plus you have to hold it down for a second to kill the motor instead of accidently making contact with it at the wrong time and killing your sled.
Similar threads
