How to wire an RSI 2 wire kill switch to the 4 factory wires? 2009 RMK 600

[SaskRMK]

I have an RSI throttle block so i no longer have the dead man switch and I'm also using the Polaris factory tether kill switch. What i need to know is how to wire the RSI kill with the bar clamp into my Polaris wiring at the original kill switch

Factory wires have two black and two black with blue stripe
RSI wiring has black and black with white stripe
Anyone wired one of these on their IQ?

On the website it says '"except 600 efi" and this is on my 2009 RMK 600.
It came with my throttle block so so I would like to have this bolted onto the bars rather than my oem switch zip tied to them. I cant see it being possible on everything but the 600?

Thanks in advance guys

http://www.rsiracing.net/catalog/pr...id=32&osCsid=a4285031b18486c1b8b1013a3a98af41

 

[SaskRMK]

To the top

 

[diamonddave]

I would call RSI and see what they have to say.

 

[SaskRMK]

they are only open mon-thur so I'll have to

No one has done this before on here?

 

[SaskRMK]

TTT

 

[MORSNO]

they are only open mon-thur so I'll have to

So what did RSI tell you?

 

[SaskRMK]

I'll have to see what they say on Monday.
Surprised no one has wired this up before