How to Change Drivers?
- Thread starter gmustangt
- Start date
S
Skidooer
Well-known member
If it slipped under boost there would be threads about it. Since there is no thread I suspect no slipping.
T
TGitt
Well-known member
I had the track off my Pro, and to get the drivers off, I took off the rear skid, track, drained the chain case, took off the lower gear and chain in the chain case, secondary clutch and the little cover thing behind the secondary. (I don't know the proper name for it but its what the other end of the drivers bolts to.) After that, it came out pretty easily.
Unlike the old poo chassis you cant just pull the chaincase as it is bonded to the frame. Pull the case cover, pull the lower gear, pull the carrier bearing on the opposite side and the shaft can be pulled out.
Old driver pressed off, new ones pressed on. I wouldn't bother doing it unless your changing to a track with a different pitch. (even with boost)
Old driver pressed off, new ones pressed on. I wouldn't bother doing it unless your changing to a track with a different pitch. (even with boost)
good to hear! the only reason i was thinking was so i wouildnt have to run track tight(robbing power).. did you find you had to run the track tight so it wouldnt ratchet?
K
Kestrel2126
Well-known member
Ran my 11 all last year on stock track/drivers. I did ratchet at first when the track was stretching out, but once it broke in, although I do have to run tension a little tighter than I normally would, it doesn't ratchet anymore. Thinking I may change to a 3" pitch setup this year, depending on how the sled likes higher boost, once my Intercooler gets here.