Anyone have a Holz rear with fox floats? If so what psi are you running in those? This rear skid hasn't had the right psi in it from the start even though it was set up to Holz specs. Thanks for any and all replies
I've found that I have had to run quite a bit of pressure to 1- minimize the amount of sag in the rear. 2- The skid would bottom out bad with recommended pressures on the big jumps and if going hard in the mogules. I called Holz and they told me to run high pressure or send the shocks in and have them re-valved. Since than I have been running ~60psi in the front shock and as high as I can get in the rear ~between 140 - 150psi.
Is yours a 151"? and what do you weigh? Those numbers sound good, I will try that. Last ride the rear looked like a freakin low rider I will see if i have a pic.
