Just working on a Holz drop and roll on a '04 VE. And was looking for a few pics of the finished project. Anyone got any? Wouldn't mind seeing the finished work.
Cheers,
Cheers,
Holz D/R pics
- Thread starter cey800
- Start date
J
Jakepol800
Member
I just did one about a month ago what kind of pictures do you need?
i got pics too if you need i can email them but can't post sorry
its a bit of a jod is'nt it i took me a while but it works good i can run a 2.5 track with 7tooth avids plenty of room
its a bit of a jod is'nt it i took me a while but it works good i can run a 2.5 track with 7tooth avids plenty of room
The kits is all in place (it was abit of work) and getting the driveshaft machined. But it looks like the only way to get the jackshaft back in is to unrivet the clutch side plate and to slide in the jackshaft. Then rivet the plate back in. Anyone else have trouble getting the jackshaft back in because of clearance? Seems like a royal pain to me.
Cheers
Cheers
ok i went out and looked at mine i think the problem your having is that you need to put the drive shaft thought the hole before you install the bearing flange and bearing
Drive shaft is fine. Its installing the JACKSHAFT that is super tight because of the the location of the new how. Which makes the loaction hard to slide it in.
ok sorry
i think i remember that i had to unbult the plastic side pannel where it meets the alum. part above the footwell the bults are under the reflecter then you can kind of spread it out and down a slide the shaft in
good luck hope this helps
garth
i think i remember that i had to unbult the plastic side pannel where it meets the alum. part above the footwell the bults are under the reflecter then you can kind of spread it out and down a slide the shaft in
good luck hope this helps
garth
Worked like a charm. Cheers to you man
glad to man let it snow
Anyone with pics of the chaincase side? Wondering about trimming the bulkhead for the brake rotor.
Thanks again guys!
Thanks again guys!
pmed ya
