HELP! CAN YOU PUT THE 13' MOTOR IN AN 11' ?

[ghost rider]

Need to know what you need to do to put a 13' motor into an 11'. I know injectors, ECU, and stator are different. What other parts or plugs do I need to make it happen? Rave valves are different I know, need to know (For Sure-100 percent) any insight or knowledge would be greatly appreciated. Thanks

 

[whoisthatguy]

PM Mountainhorse. He listed it someplace. As I recall, you get to keep the handlebars.

 

[whoisthatguy]

http://www.snowestonline.com/forum/showthread.php?t=330776

 

[Skadi]

I believe the injectors are different from 11 to 13. 12 to 13 they were in a different location but not different enough to matter. 11 to 13 I think they were different sizes so it would be hard to put 11 injectors in a 13 motor. I could be wrong on this though!

12 to 13 I don't think the injectors are different, just slight change in location from what I was told. I was told a 13 motor will be used to replace any 12s that go down on warranty work. NOT sure that is the case with the 11 though... Also, I have been told (not sure if it's correct or not though cause I'm STILL having performance issues with my sled) that the 13 works perfect on the 12 but you have to run the 12 electronics COMPLETELY and there aren't parts and pieces you can swap out. If you want to do an electrical upgrade to get to the 13 mapping you pretty much have to do it all cause they changed the ECU and the connectors used in many places.

not sure if that helps any... but I'm running a 13 motor in my 12 -but can't get it to run...