HELP!! 04 rmk 800 clutch removal...PrO help

[Iceman canada]

Hey guys....ive read all i can find but have a new one for ya.....went to pull clutch and after 10 attempts wanted to try the water trick(hydrolic)...when i poured the water in it wouldnt fill up....so went to grease.....tightened that b atch with snipe and no luck...tried to take out puller and took half hour as it was way too hard to get out...now wont even thread in.....wth!!!.....SO...can i pull the engine out with clutch in place??...thecrank is broken but i now thonk i havetrashed my clutch trying to get the b iatch off!,!....advise!!??.help

 

[rmkboxer]

you can pull the motor with the clutch on it, you can split the case with the clutch on it also

 

[Iceman canada]

So do you guys think the clutch will be junk orcan itbe fixed?...the puller needed a snipe to REMOVE the clutch puller shaft...and now it wont thread in at all...where the heck did i go wrong?....

 

[rmkboxer]

with out seeing it I could not tell you but if the puller will not thread in then ya it probably is junk

 

[im2fast4u]

update

I tried the clutch/water hydrolic method with a broken crank and filled the cases with water.....ended up tearing engine down with clutch still attached....just fyi