Handlebar Question

[151Viper]

So I have a 2010 Dragon and the other day I bent up my original pro-taper bars a bit and I am buying a set of standard RMK bars for it. I like the narower feel and I found a good deal on them. My question is I am looking at buying a 3.5" or a 5" Rox pivoting riser for it. Has anyone else made this swap and what size riser did you use? I had a 2009 Standard RMk and I liked those bars much better.

 

[SaskRMK]

I would just measure the difference of rise in the two bars and get the corresponding riser if you want it to feel the same height otherwise it comes down to your height and riding style+ personal preference.

 

[151Viper]

I was just a little short on time so I had to make a decision on which riser to order. I ordered a 3.5 rox riser. I am hoping the bar height comes out to the same. I will not have the bars or the riser until tuesday and that evening we are headed to Cooke.

 

[shmuckaluck]

Hey guys,
I have an 08 700 and I just put the 800 stock riser on it, it's only about 2 inches taller, but thats the perfect height I think.

 

[Ski-Dont89]

Hey guys,
I have an 08 700 and I just put the 800 stock riser on it, it's only about 2 inches taller, but thats the perfect height I think.

I agree

 

[151Viper]

The main reason for my question is that the standard rmk's and the dragons have different mounting systems and I am assuming that the riser considerations will be different between the two.