Hand Warmer Install Help and Info

[Hawk600]

Hello all!
I've got an 04 Hawk 600 that I’m going to try and install a set of hand warmers on. Just wondering if anyone on here has done this and could give me a few pointers.
After reading the directions it seems pretty straight forward. The only thing I’m worried about is finding a power source for them. is there a wire there for hand warmers and accessories or will I need to tap into the headlight power wire?
I remember reading a few years back that some sleds produce AC current.
The hand warmers I have are DC warmers. Does the hawk put out DC?

 

[J&L Snowhawk]

single

should be a single yellow acc. wire with a cap on it in the harness that you can use. use some heat shrink on the left handle bar before installing the hand warmer. good to go then

 

[buffaloHAWK]

you can also run 2 heat elements on the left side since the alloy bars suck up some heat compared to throttle side....

 

[snowhawk jockey]

I use the KTM grip warmer kit. It has the warmers installed into the grip and don't present the problem of heat sinking like a foil directly in contact with the bars.

 

[TKswild1]

Snow hawk Jockey

Those heated grip's you are using. I have just bought a set of the gripped hand warmer's, the yellow wire connection was easy to find. Is there a ground wire that you had to bolt on somewhere.

Thank's
-Tom

 

[Hawkdoggen]

you can just ground it to the frame on the right side of frame with the rest of your electrical grounds , (just above recoil on inside of rail )

 

[Hawk600]

I grounded mine to the MPEM aluminium cover. Oh and thanks for the help guys!!!