any tips and/or tricks to getting my 503 suspension back in and lined up properly to bolt in>? thanks.
getting suspension back in
- Thread starter egert23
- Start date
S
snowhawkaddict
Banned
Hang it up Eric!
I use the carrier that lifts the machine off the ground about four inches, relieve all track tension and remove lower jackshaft bearing carriers.
lastly back up a few months to those hot days of summer, or crank the heat to soften that hard rubber.
http://www.youtube.com/watch?v=1hKPIdMNnzQ
Why'd you scratch the aluminium up and peel those decals??
I use the carrier that lifts the machine off the ground about four inches, relieve all track tension and remove lower jackshaft bearing carriers.
lastly back up a few months to those hot days of summer, or crank the heat to soften that hard rubber.
http://www.youtube.com/watch?v=1hKPIdMNnzQ
Why'd you scratch the aluminium up and peel those decals??
Last edited:
P
predatorr03
Member
wow!
what you did to that suspension looks kickass,mind if i do the same?
what you did to that suspension looks kickass,mind if i do the same?
Yea, get some sand paper and sand all those funny marks off....All those swirls might make you dizzy and make it hard to get that thing back in......LOL
Looks great!
Looks great!
Yes Predatorr03, you can do the same thing if you would like. It took a while but I am happy with the results. As I did the swirls I put a metal polish on as well to help protect from corrosion.
TLKD, I did go with the 8" rear wheels. I also think they look good and can't wait to post up pics of it all done.... besides installing your graphic kit to arrive soon.
TLKD, I did go with the 8" rear wheels. I also think they look good and can't wait to post up pics of it all done.... besides installing your graphic kit to arrive soon.
