Fresh 670 motor, complete/running

[HPIcustoms]

Fresh 670 motor, will bring out west tomorrow

I am parting out my summit f chassis sled, and would like to get rid of the motor first as the sled is still useable. Ran the motor tonight, can email a quick vid to prove its condition. Bought the motor a couple years ago locally, I believe it to be out of a 96 or 97 formula from what I remember. Bottom end got new bearings and seals, then last winter (end of season) I did the top end (cold siezed) with bored cylinders, spi t-moly pistons. Head has no damage. Runs great, has 40 mm carbs, everything can be included (cdi, boots, recoil, airbox, exhaust manifold etc) Will do a compression test tonight when I get home, always has been a two handed start! I am looking for 1000 CDN complete, or 800 short block. (I have everything for the sled too, including a 98 sc10 skid and br tech lightweight black hood, see part out thread in ski doo for sale)

Email if interested at tscarfe@mts.net, or PM me. I am in Manitoba, but I will be going west next weekend, through calgary and on to golden if you need me to bring it out that way.

 

[HPIcustoms]

ttt....make an offer

 

[HPIcustoms]

Ok, did a compression test, keep in mind I was doing it out of the sled, holding the motor with my foot and pulling on the cord. The 670 is hard to pull like this!! Might not have gotten a good test due to this, but the numbers were good. pics are dark, but I had it on macro mode to try and make numbers visible.... vid of motor running available by email if you are interested

PTO side was just over 130 psi, MAG side was just under 150 psi.

 

[HPIcustoms]

driving west TOMORROW AFTERNOON, if anyone is interested in AB or eastern BC, now is the time to tell me!!! email tscarfe@mts.net.

 

[TPDP32]

Probably too late, but do you still have this 670 engine.

 

[HPIcustoms]

sold sorry