For those with HID's...

[jols]

Question... If no battery is required for the H4 kit on our IQ's, than where do hook the red and black wires off the control box that controls the hi/lo? I'm getting ready to install my kit tomorrow night and need some help to figure this out! Also... I have an extra ballast and an H1 bulb for my center projector beam. Can this be wired into the system as well? Any help would be appreciated... Thanks!! Matt

 

[Sledder Jorg]

Did you get a high/low set of HID's? On my sled I just recently installed HID's but only got the low beams, since I did not think I'd need high beams anymore. So for me I had no ground or red wires to connect. My sled does have a battery, but I'm assuming yours doesn't?

 

[j96simmons]

If you have " bi xenon h4 hid kit '' the hi lo wires will be in a male three way plug that will go to one of the plugs that are on your bulbs now.

In this picture in is called the connect socket.