2010 600 IQ-R Mod Sled
VERY CLEAN and VERY FAST Sled. National Level mod. Sled currently is set-up for Hill-X 136 Iceage rails, crossshaft, and billet two wheel kit with 8 inch billet idlers. Track is drilled for ISR legal stud pattern. New C@A Outlaws skis with Studboy Shaper Bars, Rox foot treads, StompGrip tunnel grips. All shocks have two races on them since rebuild, Re-valved to Polaris/Walker evens specs., front skid needle clicker shock, RCS Titanium springs. Additional rear cooler added and all additional equipment as instructed by Polaris Race Department.
All motor work was done by Larry Rugland Motorsports in Colfax, WI. Motor was ported and polished, fill and match crankcase, Reprogrammed CDI, Carbs bored and finished to 42mm, 16:1 compression, runs 110 for Sno-x and 4:1 110 and 116 mix for Hill-X, last set of LRM twin pipes for IQr chassis, flanges where cut and modified on the dyno for best results. Made 148.9hp 89.1torque at 8800RPM on Larry’s dyno which is known to read low compared to others. Still uses airbox and plenum, hood modified for twinpipes, dragon button installed, timming selector switch, and factory exhaust valve solenoids.
More Pics. http://s84.photobucket.com/albums/k17/Swamp7/2010 600 IQ-R Mod Sled/
Asking $7,800
Will not be disappointed!
Located in Reedsburg, WI
Thanks, Jake
(651)-470-4999
VERY CLEAN and VERY FAST Sled. National Level mod. Sled currently is set-up for Hill-X 136 Iceage rails, crossshaft, and billet two wheel kit with 8 inch billet idlers. Track is drilled for ISR legal stud pattern. New C@A Outlaws skis with Studboy Shaper Bars, Rox foot treads, StompGrip tunnel grips. All shocks have two races on them since rebuild, Re-valved to Polaris/Walker evens specs., front skid needle clicker shock, RCS Titanium springs. Additional rear cooler added and all additional equipment as instructed by Polaris Race Department.
All motor work was done by Larry Rugland Motorsports in Colfax, WI. Motor was ported and polished, fill and match crankcase, Reprogrammed CDI, Carbs bored and finished to 42mm, 16:1 compression, runs 110 for Sno-x and 4:1 110 and 116 mix for Hill-X, last set of LRM twin pipes for IQr chassis, flanges where cut and modified on the dyno for best results. Made 148.9hp 89.1torque at 8800RPM on Larry’s dyno which is known to read low compared to others. Still uses airbox and plenum, hood modified for twinpipes, dragon button installed, timming selector switch, and factory exhaust valve solenoids.
More Pics. http://s84.photobucket.com/albums/k17/Swamp7/2010 600 IQ-R Mod Sled/
Asking $7,800
Will not be disappointed!
Located in Reedsburg, WI
Thanks, Jake
(651)-470-4999