Fabcraft tie rod end replacement?

[Thatspec]

Ya know I never thought I was all that hard on things but...

Has anyone sourced one of these from anywhere else, it's the smaller upper.
I'm finding far too little in the way of dimensions from internet sources, can't tell if it's metric or sae... It's about 1" across the ball bore.

Thanks in advance

 

[Thatspec]

So it appears this is not a part that comes with the Fabcraft trailing arms at all and is a stock polaris part 7061061. No wonder they bend like butter
Anyone replaced one of these or similar with a non oem part. Best I've seen is $25 on Ebay but most places want $35. The ball bore is about an inch in diameter making it a little unusual but maybe spacers could be used with a more generic rod end?

Buehler?

 

[markis24]

Figure out what thread they are and look at hd aurora ends.

http://www.hiperf.com/acatalog/Snow...eous_Performance_Accessories_70.html#aRODENDS

 

[Thatspec]

Thanks guys, I've talked to HPE and the Auroras would require a spacer or washers. I have feelers out through several parted out sled threads but so far nobody is getting back to me. For the amount of time i've put into researching this I'd have been many $'s ahead spending full retail at a stealer