Engine light on 13 pro

[t stone]

I rode all day yesterday with no issues. I got home and unloaded my sled. I fired it up and let it warm up to about 90 degrees and figured that was warm enough to get it into the garage. When I gave it throttle the engine light came on and it bogged. I let off the throttle and tried it again, same thing. The light only came on when I gave it throttle. I then pulled off the teather figured it wasnt on all the way. Put it back on and still did it. ?? Then the light went out and the bog went away and ran fine into the garage. Anyone have any ideas what it could have been? I dont want to haul it to the shop if I dont have to.

Stone

 

[jhurkot]

Does the sled idle at 1500-1800 rpm and go into reverse? If so I would say it's not your TPS. Check your throttle block for ice and make sure that the flipper moves freely where it contacts the throttle safety switch. If you have problems with it while riding take your TSS right out and tape the plunger in the pushed in position and see if that makes it go away.

 

[t stone]

Yes, It idles fine. Nothing iced up. It just did that 3-4 times and then went away. Would the computer show a code even though I turned the engine off ?

Stone

 

[Kiputah]

Mine did this same thing yesterday. Took about 5 min to finally let me go. Good thing I was way back in the mtn's. happened after it sat for 30 min lunch. Mine pulled up a error code just need to look it up. I'm sure yours is the same error code. Your Manuel will tell you what the code means I hear?