Edge Skid Setup

[Vertical_Escape]

I'm probably going to get blasted for not using search because I know I've seen a couple threads addressing the correct settings as a baseline, I tried with no luck.

Any of you Edge gurus care to give a little advice. I'm looking for the proper setup to allow sled to get up on top quick. With new motor pumping now all sled wants to do is go digging for dirt.

Any help is appreciated.

 

[sled_guy]

You want the front rear shock in it's laid down position, top of it below the top shaft. If it has an adjustable spring on it back all the preload out of the spring until it is just barely contacting the retainer, then put 2 turns on it to keep the retainer from coming off.

Let the limiters all the way out.

sled_guy

 

[Vertical_Escape]

That's what I thought I remembered reading, wasn't positive though.

Thanks for the quick response.

 

[sl*dhead6]

Ditto with Sled-Guy!